Saturday, 14 December 2013

Start of the Winter Overhaul

Constantly alternating between full throttle, hard braking and high g-force cornering will take its toll on any car. The Porsche Boxster handles this better than most, so our winter overhaul is more akin to a full service and some preventative maintenance. No full strip down and rebuild needed!

First job was to remove the starter motor.  This has been getting more and more sluggish recently, struggling to start the car when the engine is hot.  
 
It sits on top of the engine so removal of the throttle body and air intake make it easier to get to.  These are cleaned up as we go, as is the BMC performance air filter which is has to be washed and re-oiled.   A two- foot-long 2 foot socket extension is needed to get to the last bolt, which is accessed through the engine cover behind the seat.
Top of the engine minus throttle body and starter motor
While we are in this area of the engine, the oil air separator is notorious for failing, allowing oil to be sucked into the engine.  Our intake showed some signs of oil residue. There is a motorsport version - but this isn't available for our earlier model car.  Special hose clips and small arms from above and below are needed to replace this. 

Lastly we turned our attention to underneath the car where we've been seeping fluid.  A length of hose had to be cut out. Initially we thought this was power steering fluid, however it turned out to be coolant. Porsche factory fill with a yellow liquid which isn't available any more. Given the potential problems with mixing different coolant types we'll flush the system completely and refill after replacing the hose.  

Phase two in the new year will be to change the oil and filter, then replace the front bumper.   Finally we'll be removing more unnecessary wiring and getting a lighter weight exhaust fitted. 

Monday, 21 October 2013

BRSCC Finals at Donnington Park

We arrived at Donington Park late Friday evening and unloaded into a Pit Garage.  We'd hired a different trailer this weekend and found out too late that you cannot open the car doors due to the high wheel arches.  This meant climbing in though the roof to get the car off the trailer which was entertaining.

Qualifying (Saturday 11am)
The track was wet from overnight rain and the single seaters before us were out on full wet tyres kicking up spray down the main straight.  I expected it to dry out, and my lap times increased throughout the session as a dry line appeared in places. Everyone went fastest on the last lap, but I was hampered a little by traffic so could have gone quicker. I qualified 12th.
Photo Courtesy of @Sportscarfan917
Race 1 (Saturday 4pm)
I got a decent start off the line but several cars jumped the start, rolling before the lights went out. As I rounded the first corner (Redgate) the cars in front suddenly all swerved left (to avoid a spinning car). I had to take avoiding action, ending up with two wheels in the gravel and two in the mud verge going nowhere fast.  By the time I rejoined the circuit I was almost dead last.

The 20 min race saw me pass all of the 924 runners, the two production boxsters and catch the race spec boxsters. There were no blue flags to help as we were racing for position. I crossed the line side by side with 13th place (0.2 secs behind). Both of us gained an extra place when the jump start penalties (10 secs) were applied. 
 

After the race we noticed the exhaust was sounding pretty rough. On stripping the bumper off we found the lambda probe had corroded and blown out of the catalytic converter leaving a 50p piece size hole.  With the help of Tony from Southshore Tyres we managed to weld it back on, racing with a blowing exhaust.

Race 2 (Sunday 12pm)
Having rained in the morning the track was still wet for our 12pm race.  I knew it would dry quickly so set dampers fairly stiff, mindful it would be slippy off-line.

The race was red flagged at 2/3 distance and restarted for an accident. I finished my best ever in 6th having great battles with other cars for that position in both parts.  The car handled really well and my driving was quite smooth - although my lap times were 1 second slower than 2012.
With confidence high we stiffened roll bars and dampers for the last race which was a reverse grid (starting 8th in boxsters).  Just before we went out a torrential downpour soaked the track so we hastily changed to a wet setup.

On lap 1 visibility was almost zero from spray and I got stuck behind a train of cars whilst faster cars overtook all of us. On lap two I used the wet race line with good effect to take 3 places back and open a big gap. I was now in 6th place.  A car spun on the oil immediately in front of me resulting in a very close call.



I eventually got caught on the last lap - finishing a very happy 6th place again!

Monday, 14 October 2013

Donnington Park Wet Practice

With no Friday test being offered by Donnington Park we chose a Bookatrack trackday the week before our race weekend to get some practice laps in.

At a first glance Bookatrack look a little more expensive that some other track day operators.  However their approach is to limit the no. of cars taking part (up to half of other track days) which ensures you get maximum track time from the day.

The day was well really run, with a mix of race,track and supercars all behaving on track in pretty tricky wet conditions.  Persistent rain for most of the day threatened to close the track at times as rivers of water flowed across the tarmac in several places. 


We used the day to asses wet weather handling at different tyre pressures and damper settings.  We also experimented with different race lines.  Overall we improved our times by 4-5 seconds by the end of the day in worsening conditions.

We also tested out a new hardwired Blackvue camera to meet a newly introduced championship regulation (mandatory in car camera recording). This records whenever the ignition is on saving us the aggravation of usb charging, memory card management and forgetting to press the record button!
 

Saturday, 7 September 2013

Steering Arm Replacement

We noticed quite a while ago (last year in fact) that one of our steering arms was badly bent at the join with the track rod end.  Since we are skipping a couple of race events, after a busy summer, this job has now reached the top of the priority list.

Having put the car on axle stands, removed the wheel and front under-tray, you can get access to the inner joint of the steering arm.

There is a design fault though!  The steering column wont extend far enough to clear the front sub-frame and enable you to get a spanner onto the inner joint.  As it happens we had the perfect offset 32mm wrench already in our toolbox.  It's a special offset wrench for tightening a Ford / BMW engine fan from the 1990's. 



With the inner joint undone it took another half an hour to reassemble, ensuring the same no. of threads were showing at the adjustment end so the tracking would not be wildly out.

Once finished we reset the tracking using our basic strings approach, setting 2mm of tow out in place of our previous straight alignment.  In theory this will help the car turn in on the corners.  This is quite aggressive and we'll see if it makes a difference when we practice for the Donnington Park round in October.

Monday, 12 August 2013

Brands Hatch Race Event

As usual it was an early start on the Saturday. We arrived at the paddock entrance just behind our race car which was being towed separately and found space in the paddock.
There was only just time to unpack the car before we need to head over to scrutineering, remembering I had to sign-on at the office on the way.


The cars queue through scrutineering where the saftey features of all cars are checked. Seats and belts must be firmly mounted and in date. Lights and safety cut-off switches must work etc. They also check my race suit, boots, gloves and helmet for condition and the right safety markings.  All my gear is FIA standard and equal or above that needed for UK club motorsport.

 



Qualifying - Saturday AM
A long queue formed early.  With 30 cars on the short 1.2 mile Indy Circuit everyone wanted to be out first.  I got some clear laps by being last out of the Boxsters with only a couple of 924's to clear on my out lap. Almost every other lap you came across traffic though. I qualified 13th, not quick enough, but happy to be around 1.5 seconds a lap faster that the year before when I was battling 924's and without any incidents.

Race 1 - Saturday PM
We softened the rear roll-bar from the Snetterton setup as I was struggling in the tight corners with understeer and squealing tyres in qualifying.  We also reduced tyre pressures as the outside temp got up to 25 degrees. We know tyres heat up during a race and are looking for 26-28 psi when hot. Any higher and the tyres start to loose grip with car sliding about more under braking and in corner exits.


On the grid I had to balance the hand-brake, accelerator and clutch as the middle rows slope downwards temping a false start. (Or stalling as the car next to me did!) 

I got away OK, but was too wide round Paddock Hill and too cautious on lap one. There was a lot of pre-race warnings about damage, the need for good driving standards and my caution lost me a couple of places around the Druids hairpin.
 

After 3 or 4 laps I was dropped by the mid pack of racers and was racing alone. I had to keep pushing though as a couple of spinners in front got me one place back, finishing a reasonable 12th and improved my fastest lap of the weekend so far by half a second.


Race 2 - Sunday AM
I again started well holding position. I gave a place up round paddock hill on lap 3, but the driver went into the gravel on the next lap pushing too hard. Then another spinner bought out the safety car, allowing everyone to bunch up again.


After the restart I was able to stay with the cars in front, who were all navigating back markers within a couple of laps.  I saw a gap to nip past 10th place at along the short Cooper Straight when a wheel was put on the grass, however being a more powerful 987 model it blasted past on the pit straight and I couldn't get back underneath at paddock hill bend to hold the place on the brakes.  I finished 11th after a great race and and once again went faster and put in more consistent fast laps.

Race 3 - Sunday Late Afternoon 
I was tempted to change the car setup prior to this race.  I had been interviewed by the AJK TV crew and stated I needed to find another half a second per lap to get amongst the mid pack of cars.  In the end we decided to brake more gently for Paddock Hill and attempt to carry more speed around the corner, more smoothly, and be on the power earlier.  

I held position after the start, but had a faster car/driver harrying me around the first 3 laps.  When he moved to the inside I had to yield at Druids Hairpin to avoid any contact.  Once behind however the tables were turned.  Whilst I was always loosing out on the pit straight I was faster by trail-braking around Druids and being hard on the gas through Surtees & McLaren.   
 
I posted 6 laps back-to-back all around the 56.5 seconds lap-time mark and slowly reeled in the car in front. There was a moments hesitation overtaking a back marker and I went passed with two wheels on the grass on the outside of Graham Hill Bend.
I immediately opened up gap and then managed it to the end of the race to finish a very satisfying 10th.

Summary
This event saw not my fastest driving in terms of finishing positions, but definitely my most consistent and smoothest driving in the two races on Sunday.  It took that long to get used to the track again after a year away, which is the benefit of testing or having a recent track day under your belt.

Thursday, 18 July 2013

Snetterton Race Event

Practice (Friday AM)
I stopped in the pit lane after 2 laps to check tyre pressures and was alerted to water leaking from the back of the car.  It looked like we had not screwed the water cap on correctly and the car boiled over. I tried to get back out on track, but the engine was overheating, so we retired to our paddock base.  It took over an hour to cool the engine, refill and bleed the system and get back on track.
Over the lunch break we finally fitted new tyres. (The original set lasted 6 race weekends, 2 test days and 2 track days which is good value for money).  In the afternoon we got some good track time, but only ever put 3/4 of a good lap together, getting into the 2m 17s.  For the last session we stiffened the rear anti-rollbar to maximum, and this helped with more predictable handling (light understeer) through the fast corners.


Qualifying (Saturday AM)
I got myself clear track for most of the session and went over 1.5 seconds faster than in testing the day before.  The car handled well and I hit most of the apex and exit curbs for a really good lap.  I qualified an excellent 9th (2m 16.1) out of 14 Class-A Boxsters and 31 cars in qualifying.

Race 1 (Saturday PM)
In the afternoon the temperature soared to 30 degrees in the paddock.  We made no changes to the car bar reducing tyre pressures. I missed 2nd gear off the start line and went backwards a couple of places, then I lost a couple more navigating cars which had spun at the first hairpin, so not a great start.


On lap 3, I overtook a car which was slow out the fist corner, but couldn't stop on the dusty inside line into the hairpin.  Unfortunately I clipped and spun another car ahead in the hairpin. Both cars recovered and I decided to just bring the car home (now without working ABS).  However on the penultimate lap I spun when I misjudged my braking losing another two places.  

In park ferme my car was found to be leaking all the water out of the back again!  This time with a definite split in the coolant tank due to the extreme heat.
Luckily TF Motorsport had a spare at their workshop, so we hatched a plan to collected this at 7am Sunday and with the help of an extra pair of hands from another driver the car was ready by lunchtime. This was a major feat for us, as this is a very time consuming and difficult repair job.

Race 2 (Sunday PM)
I got a reasonable start but there was no room to pass a car two rows ahead who didn't.  I was faster in a number of corners, but never quite got close enough to pass.



After 3 or 4 laps I was finding it harder to maintain corner apexes as my tyres started to overheat.  With two laps left I was a sitting duck up the main straight and I was passed on the outside.  Unfortunately the driver spun a lap later - just pushing too hard.  I got another place back to another spinner and finished much happier in 10th.

The Championship moves to the short Indy circuit at Brands Hatch in just 3 weeks time, so there is no opportunity to do any work to the car before then.